American-expedition-vehicles JK 2.0 Spacer Suspension Manuel d'utilisateur

INSTALLATION GUIDE2.0” Spacersuspension systemAEV30211ACLast Updated: 01/27/14

88.A. Drill a 3/8 inch hole in the center of the axle bump stop pad.B. Place bump stop spacer inside springs.C. Install Front Spring Spacers, keep

99.A. Install new sway bar end link brackets and tighten to 80 ft lbs. Reinstall end link to bracket and tighten to 75 ft lbs. NOTE: Right Hand Drive

10.For 2011 and newer models, use supplied zip ties to secure the brake line to the shock as shown.Reinstall wheels and tighten lug nuts, working in a

jk Factory Torque Specifications*nominal torque shown in ft. lbs.appendixFront Suspension & SteeringUCA bushings M12 75LCA bushings M14 125Track b

PLEASE READ BEFORE YOU STARTTO GUARANTEE A QUALITY INSTALLATION, WE RECOMMEND READING THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING ANY WORK. THESE I

1REAR SUSPENSION1.A. Raise Jeep and support the frame using jack stands or a hoist, such that the rear axle can be lowered enough to remove the sprin

22.A. Remove the bolts that hold the brake lines to the frame.B. Remove the shocks.C. Remove the lower bolt for each swaybar end links.A.B.B.B.

33.A. Carefully lower the axle using the oor jack enough to remove the springs. DO NOT overextend the wheel speed sensor or locker wiring.B. Remove

44.A. Install new Bump Stop Spacers on axle as shown using the supplied hardware. DO NOT reverse the orientation from what is shown.B. Install the s

55.A. Raise axle slowly and guide springs into position.B. Reinstall lower sway bar link bolt and tighten to 60 ft lbs. (Refer to step 2C.)C. Reins

6FRONT SUSPENSION6.A. Raise Jeep and support the frame using jack stands or a hoist, such that the front axle can be lowered enough to remove the spr

77.Note: On Rubicon models, remove the push pins holding the speed sensor wiring to the frame and upper control arm.A. Remove anti-sway bar link lowe