American-expedition-vehicles JK Premium Front Bumper Manuel d'utilisateur

INSTALLATION GUIDEPREMIUM FRONT BUMPERAEV30103ADLast Updated: 12/03/13US PATENT: D683,281 CHINESE PATENT: ZL 2012 3 0026032.0

89. Remove the two bolts temporarily holding the fairlead bracket to the bumper if the winch plate was not installed.10. Loosely attach the closeout

PLEASE READ BEFORE YOU STARTTO GUARANTEE A QUALITY INSTALLATION, WE RECOMMEND READING THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING ANY WORK. THESE I

1I. Remove factory componentsA. Remove the factory air dam1. Remove the “Scrivet” fasteners at the front and back side of the air dam. Use a Philli

2B. REMOVAL OF THE FRONT BUMPER1. If you have fog lights disconnect the wiring.2. Remove the and discard the 8 nuts attaching the bumper to the fra

3II. VEHICLE PREPERATIONA. MODIFY FOG LIGHT WIRING FOR PREMIUM BUMPER ONLY(NOTE: 2007-2009 USA, CANADA, AND MEXICO MODELS ONLY)1. The fog lights ar

4B. MODIFY FOG LIGHT WIRING FOR PREMIUM BUMPER ONLY(NOTE: 2010+ USA, CANADA, AND MEXICO MODELS ONLY)1. Remove the tape from the wire harness on the

5III. INSTALL BUMPER KITA. TOW LOOP BRACKET INSTALLATION1. Place tow loop bracket on the vehicle frame.2. Slide the nut plate into the frame and lo

6B. WINCH PLATE InstallationIf you are installing an AEV Winch Mount with your Premium Front Bumper you may now refer to the In-struction Sheet inclu

7D. Premium Bumper Installation1. Install the mesh into the bumper over the studs and tighten M6 ange nuts.2. Install the crush can covers with M6