INSTALLATION GUIDERoof RackAEV30209AALast Updated: 10/18/12
8C. assemble stantions1. Pre-Assemble all four stantions as shown (g. 11) leav-ing nger tight at this time. NOTE: Additional hardware is included
9Important Information:Maximum carrying capacity: AEV can not recommend a weight carrying capacity. Refer to your Jeep owner’s manual.It is essential
PLEASE READ BEFORE YOU STARTTO GUARANTEE A QUALITY INSTALLATION, WE RECOMMEND READING THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING ANY WORK. THESE I
1part i. Platform assemblya. assemble outer frame1. Attach corner close out plates to bottom of corner pieces using the supplied screws (Fig. 1).2.
2b. plank assembly1. Carefully place outer frame upside down on a clean, at surface.2. Slide the platform planks under the frame one end at a time
3Part ii. Installing roll–BAR brackets1. Remove hard top.2. Remove sound bar.3. Unzip roll bar padding and pull back to expose factory brackets (g
4Figure 7.1 front Figure 7.2 rearFigure 843 inches(109.22 cm)32 1/4 inches(81.92 cm)Front of Vehicle
5Part III. RELOCATING SATELLITE ANTENNA1. Attach satellite radio antenna, using its original hardware, to the AEV provided bracket.2. Remove all tri
66. Fasten AEV bracket with satellite radio antenna to the windshield frame with the supplied bolt, nut, and washer through existing hole in the top
7Part IV. Attaching platform to hard topa. Marking hard top1. Reinstall Hard top on Vehicle. Top should be completely secured with all factory faste
Commentaires sur ces manuels