American-expedition-vehicles JK Hemi Builder Kit - Installation Guide for 07-11 Manuel d'utilisateur télécharger pdf (Page 13)

Fig. 2

c. installation of the transmission mount

1. All 5–45 Transmissions must have the 3/4 Ton or 1 Ton Dodge 4WD adapter

(Mopar 52119433AB) installed prior to the transmissions mount.

2. Install the AEV Mount to the 4WD Adapter on the transmission using the stock bolts.

3. Install the stock JK transmission isolator to the AEV Transmission Mount using the two

3/8” x 1” bolts, nuts, and washers and two 1/2” x 1” bolts, nuts, and washers.

D. installation of the cross-member mount

1. Begin by bolting the top plate of the transmission cross member mount to the JK transmis-

sion isolator using the stock hardware.

2. Bolt the top plate of the transmission cross member mount to the JK cross member using 4

of the 1/2”–13 bolts, washers, and ange nuts.

3. Bolt the top plate of the transmission cross member mount to the bottom of the JK cross

member using three of the stock bolts into the cross member nutserts. Drill out one hole

using the bottom plate as a drill template. Use the remaining two 1/2”–13 bolts, washers

and ange nuts to secure the bottom plate to the cross member.

4. Weld top and bottom plates as shown (Figure 3.)

5. Paint any raw material and welds.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Pas de commentaire

American-expedition-vehicles JK Hemi Builder Kit - Installation Guide for 07-11 Manuel d'utilisateur Page 13