American-expedition-vehicles JK Rear Bumper/Tire Carrier Manuel d'utilisateur télécharger pdf (Page 7)

B. INSTALL THE SADDLE BLOCK

1. Install the plastic Saddle Block using the

3/8”x1” bolts with 3/8” washers under the

head of each bolt. Install the bolt into the

countersink on the Saddle block. Use the 3/8”

Flange nuts on the inside surface of the AEV

Tire Carrier Bracket.

2. Adjust the Saddle Block to its MIDDLE adjust-

ment.

3. Using hand tools only torque the bolts down to

20 ft/lbs (27.1 N-m) max.

4. 2010+ MODELS ONLY: The exhauster on

2010s is wider than earlier models and must

have the top left corner trimmed in order to t

the AEV Bracket.

1 2 3 4 5 6 7 8 9 10 11 12 ... 18 19

Pas de commentaire

American-expedition-vehicles JK Rear Bumper/Tire Carrier Manuel d'utilisateur Page 7