American-expedition-vehicles ProCal Module Quick Reference Guide Manuel d'utilisateur télécharger pdf (Page 2)

(Store this Quick Reference Guide with the Owner’s Manual for future use)

Programming Functions

Set the dip switches according to this Quick Reference Guide

and, with the engine off and ignition on to the RUN position,

plug the module into the OBD port. The RUN position is two

“clicks” in with the key, all the lights on the cluster should

be on in RUN mode. The horn will sound twice when the

programming has been successfully completed. After the

horn sounds, remove the Procal and cycle the ignition off

and then on again.

Runtime Functions

Set the dip switches according to this Quick Reference

Guide and with the conditions in the user guide met, plug

the module into the OBD port. Some functions will require

special conditions like the e-brake to be set and/or the

engine running before plugging the Procal in for example.

User Guide

Please consult the User Guide for detailed information

regarding each mode and troubleshooting.

Online documentation

Digital versions of this Quick Reference Guide and the

Procal Module User Guide are available online at:

www.aev-conversions.com/education/installation-guides

INSTRUCTIONS TIRE SIZES 24”—38” TIRE SIZES 39”—54” LOW TIRE PRESSURE THRESHOLD

1 1 1

2 2 2

3 3

Set the rst 3 DIP switches as shown. Set the rst 3 DIP switches as shown. Set the rst 3 DIP switches as shown.

Use the chart below to set the next 6 for your

preferred tire pressure threshold.

* Setting the TPMS to a disabled value is for

diagnostic purposes only, see User Guide for details.

This option may be restricted in some areas.

Enter your exact tire

measurement to the

closest .25 inch

Enter your exact tire

measurement to the

closest .25 inch

A AB B

34.75” Tire Example: A = 34 b = .75 44.75” Tire Example: A = 44 b = .75

Using the A value from step 2, use the chart below

to set the next 4.

Using the A value from step 2, use the chart below

to set the next 4.

Using the B value from step 2, use the chart below

to set the last 2.

Using the B value from step 2, use the chart below

to set the last 2.

DISABLING TpmS*

Dip switch settings in this guide

assume the Procal Module is held

in this position.

__________ . _________ __________ . _________

example:

up, down, up, down, down...

1 2

Commentaires sur ces manuels

Pas de commentaire

American-expedition-vehicles ProCal Module Quick Reference Guide Manuel d'utilisateur Page 2

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la voiture American-expedition-vehicles ProCal Module Quick Reference Guide