JK WINCH MOUNT Installation Guide – AEV30111AC (Updated 07/2/2013) Page 1 of 10
IMPORTANT NOTE: When installing the Winch you MUST use the AEV supplied washers along WITH the hardware included with your winch kit (as shown.) This
This page left intentionally blank Page 2 of 10
PLEASE READ BEFORE YOU START IN ORDER TO INSTALL THIS PART PROPERLY YOU OR YOUR INSTALLER MUST READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING TH
A. INSTALLATION 1. You will need to remove the front bumper and fairlead bracket from the vehicle if previously installed 2. Start with removing the
helpful to hold them in place. 6. Place the winch onto the winch mount. Do not install winch mounting bolts at this time. You will do this later af
C. WINCH PLATE INSTALLATION - 2012 AND NEWER 1. Remove and save the 2 M6 nuts and lift the vacuum pump off the factory bracket. 2. Assembl
3. Drill out the lower mounting hole to 1/2" as shown to allow the bolt to pass through. 4. Depending on the winch being installed yo
Page 8 of 10
5. Assemble the winch plate and fairlead brackets together. Use the M12 hex head bolts and flange nuts going from the bottom up(washer not needed) a
Commentaires sur ces manuels