American-expedition-vehicles JK WINCH MOUNT Manuel d'utilisateur télécharger pdf (Page 4)

A. INSTALLATION

1. You will need to remove the front bumper and fairlead bracket from the vehicle if previously

installed

2. Start with removing the (4) 3/8” bolts on the backside of the bumper, which attach the

bumper to the closeout brackets

3. While a helper holds the bumper in place remove the main (8) button head bolts.

4. Make sure you have a good hold of both the bumper and fairlead bracket. Remove from

vehicle

B. WINCH PLATE INSTALLATION 2007-2011 VEHICLES (FOR 2012

VEHICLES PROCEED TO STEP C)

1. Assemble the winch plate and fairlead brackets together. Use the M12 hex head bolts and flange

nuts going from the bottom up(washer not needed) as shown above

2. Place the winch mount assembly into position onto the frame as shown on the next page

3. With the winch mount aligned, bolt the winch mount to the lower frame attachment points using

the M12 hex head bolts, washers, and nut plate

4. FOR 2007-2011 USE THE SUPPLIED LARGE THICK WASHER BETWEEN THE WINCH

MOUNT AND FRAME AS SHOWN. THERE IS ADDITIONAL HARDWARE AND BRACKETS

INCLUDED IN THE KIT FOR 2012 VEHICLES ONLY.

5. Install the square nuts that come with the winch kit into the winch and feet. A little silicone is

Page 4 of 10

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

American-expedition-vehicles JK WINCH MOUNT Manuel d'utilisateur Page 4