American-expedition-vehicles JK High Steer Kit Manuel d'utilisateur télécharger pdf (Page 2)

PLEASE READ BEFORE YOU START

TO GUARANTEE A QUALITY INSTALLATION, WE RECOMMEND READING THESE INSTRUCTIONS

THOROUGHLY BEFORE BEGINNING ANY WORK. THESE INSTRUCTIONS ASSUME A CERTAIN

AMOUNT OF MECHANICAL ABILITY AND ARE NOT WRITTEN NOR INTENDED FOR SOMEONE NOT

FAMILIAR WITH AUTO REPAIR.

INCLUDED PARTS QTY REQUIRED TOOLS

Passenger-side Front Axle Bracket 2 7/8” drill bit for metal

Driver-side Front Axle Bracket 1 High-torque drill motor

Draglink 1 Floor Jack and two Jackstands

Steering Damper 1 or Vehicle Lift with tall Jackstands

Shock Doubler Bracket 2 Torque Wrench (ft-lbs)

These instructions assume you have the following factory parts installed on your JK:

1. JK frame and front axle with all relevant brackets in tact.

2. Front track bar (aftermarket units will work ONLY if they can be adjusted to stock length.

3. Factory steering linkage (tie rod and part of the drag link will be retained.)

4. Rear stabilizer end links (or equivalent length) to use in front.

1 2 3 4 5 6 7 8 9

Pas de commentaire

American-expedition-vehicles JK High Steer Kit Manuel d'utilisateur Page 2