American-expedition-vehicles JK High Steer Kit Manuel d'utilisateur télécharger pdf (Page 4)

2. Add the supplied u-bolt and nuts (visible in Fig. 4).

3. Insert the supplied spacer tube between stock track bar bracket and new bracket (Fig. 2-B), lining it

up with the original track bar bolt hole. (This may require slight prying or tapping with a hammer.)

4. Pre-assemble the second bracket as shown (Fig. 3) with the supplied bolt, washers, and free-spinning nut.

Figure 3

5. Install this bracket in front of the stock track bar bracket on the axle and line up the small holes with

the corresponding ones on the axle bracket. Insert the remaining two 3/8”x 1.0”L bolts and washers

from the front through the brackets, add nuts and hand tighten.

6. Insert the 1/2” x 1 1/2”L bolt through the factory stabilizer tab on the side of the axle and the corre-

sponding bracket hole and add the locking nut.

7. Place 9/16” x 3 1/2”L bolt through original trackbar hole, both brackets, and supplied spacer tube.

8. You may now tighten all fasteners.

22 ft/lbs

40 ft/lbs

100 ft/lbs

22 ft/lbs

Figure 4

1 2 3 4 5 6 7 8 9

Pas de commentaire

American-expedition-vehicles JK High Steer Kit Manuel d'utilisateur Page 4